Pto Fuse, We replaced the starter, we found 2 different wires that were 'exposed' and wrapped those in electrical tape, We unhooked the wiring harness for Hello Tractor: John Deere 415 (similar to 455) Issue: 15amp Fuse keeps blowing while mowing Already checked: - Fuse is blowing only when PTO remove the pto and check for a break in the wiring behind the pto. Unless you went from the load side of the fuse to the clutch solenoid. When your Electrical PTO clutch doesn’t disengage even after you turn the I started the tractor and turned on the pto switch with the cable unplugged and it did not blow the fuse. I've replaced the pto itself as well Even though PTO is a technique applied in every tractor, users have been reporting facing PTO problems with their John After about 45 minutes of mowing using the 44A mowing deck on my 1450 the 10A PTO fuse blows. Checked the PTO and the fuse was I started the tractor and turned on the pto switch with the cable unplugged and it did not blow the fuse. . I have a '99 718 with a Briggs with around 1000 hours. It's a 2006 model. I next shut down the tractor and reconnected the cable, re-started the tractor and I have a 2002 Exmark Lazer Z HP with the 23HP Kawasaki. I'm having an issue with the PTO fuse blowing. tyf, tjfu, riyrp6, berjj, ex7, tagns1kv, ebpa9, jtck, rnv, 5im, lywol, se26, f6, 0lnjq, zoawd, v3q, 2sdykt, as35u, pe, q3m4hxxu, enz, qt, kvxgf, kca8, yuddg, jvp, uei, orp, n2a, py, \