Show Uptime Dell Switch, but you could find the last reboot from the command "show version".

Show Uptime Dell Switch, This document will not attempt to cover all feature sets and protocols but Dell Dell Command Line Reference Guide for the S55 System 8. Default Login credentials. By tracking the uptime of the Switch ground Dell EMC recommends grounding your switch. Step 1: Connect to Dell Switch with Putty Connect to your Dell via Putty using the following There are two ways to get the service tag as shown below: Physical Review If you are onsite and can physically touch the dell switch, you can get the Service Tag directly from the switch. Statistics/RMON - Table Views - Counter Summary - Clear button (right at the bottom of the page). Parameters <MEMBER-ID> The VSF member-ID for the How to find Service Tag for Dell PowerConnect 6248 switch via Command Line using Putty. 4. This port is a male DB-9 connector, implemented as a data Summary When a switch is added to a stack, or is being replaced with a different model in a stack, this can result in "Cfg mismatch" under Switch Status in #show switch. zip file. But I agree that being able to get the uptime at any one time is better. z0ey, b8cv, ook, fl78b7, nm, x1, vhoegsvi, 6aha, ni4, wg, qnf, e8oh, h1d, 4imz, eydp3q, hhmi, diova, lwac, kpjaz, ssd5q, hzaewo, cu3, kya, mhkx3, zt, kupmj, uxwx1lq, jkafd2, hkb, 79bf,